MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
MTL7707+ for switch inputs and switched outputs
The MTL7707+ is a 2-channel shunt-diode safety barrier similar to the MTL7787+ but with built-in electronic overvolt protection. It is intended primarily for safeguarding a hazardous-area switch controlling a relay, opto-coupler or other safe-area load from an unregulated dc supply in the safe area.
The outgoing channel accepts supply voltages up to +35V and is protected against reverse voltages: the return channel is unaffected by voltages up to +250V. In normal operation the protection circuit introduces only a small voltage drop and shunts less than 1mA to earth, so its overall effect is minimal. If the supply voltage exceeds about 27V, however, causing the Zener diodes to conduct – or if the safe-area load has a very low resistance – the supply current is limited automatically to 50mA, protecting the fuse and power supply and enabling the loop to continue working.
ADDITIONAL SPECIFICATION of MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
Safety description
28V 300Ω 93mA, terminals 1 to 3
28V Diode, terminals 2 -4
Supply voltage
10 to 35V dc with respect to earth
Output current
Up to 35mA available
Maximum voltage drop
(at 20ºC, current not limited)
Iout x 345Ω + 0.3V, terminals 1 to 3 Iout x 25Ω + 0.9V, terminals 4 to 2 Supply current Iout + 1.6mA, supply <26V
Limited to 50mA, supply >28V or low load resistance
MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
Analogue Input - 2-wire transmitters, 4-20mA conventional and 'smart' |
||||
Power Supply | Barrier |
Loops
|
Voltage for Tx
and lines |
Main features |
Regulated | MTL7787+ |
1 |
12.4V
|
Compatible with most smart Tx's |
MTL7787P+ | 1 | 13.1V | Higher power, IIC gases | |
MTL7788R+ | 1 | 13.7V | 1-5V safe area ouput | |
Unregulated 20 to 35V |
MTL7706+ |
1
|
15.5V
(250ohm load) |
High accuracy; compatible with most smart transmitters; full output voltage available independently of supply voltage |
MTL7707P+ | 1 | 13.0V | Higher power, IIB gases | |
|
Analogue Input - vibration probes |
|||
Power Supply | Barrier |
Loops
|
Main features |
Regulated | MTL7796– | 1 | For –24V systems |
|
Analogue Input - gas detectors |
|||
Power Supply | Barrier |
Loops
|
Main features |
Nominal 6V supplies | MTL7758+ | 1 |
For high current/low voltage MTL7758+ Vwkg = 6.0V |
|
Analogue Input - thermocouple & mV sources |
||||
Power Supply | Barrier |
Loops
|
Max end to enc resistance per loop |
Main features |
Earth-free signal, receiver input floating |
MTL7760ac | 1 | 150 ohm | – |
Moving coil or low resistance receivers | MTL7755ac | 1 | 38 ohm | – |
|
Analogue Input - ac sensors, photocells, microphones & flowmeters |
||||
Power Supply | Barrier |
Loops
|
Max end to enc resistance per loop |
Main features |
Earth-free signals up to a few kHz |
MTL7760ac | 1 | 150 ohm | – |
|
Analogue Input - slidewire displacement transducers |
||||
Power Supply | Barrier |
Loops
|
Vwkg | Main features |
For nominal 6V supplies |
MTL7760ac | 1 | 6.0V | – |
|
Analogue Input - 2, 3 and 4-wire RTDs |
|||
Power Supply | Barrier |
Loops
|
Main features |
2-wire | MTL7755ac |
1 |
2 channels track to 0.15 ohm |
3-wire | MTL7755ac | 2/3 | End-to-end resistance 19 ohm/channel |
MTL7756ac | 1 | End-to-end resistance 19 ohm/channel | |
4-wire | MTL7755ac |
1/2
|
Needs 2 barriers |
MTL7760ac | 1/2 | Vwkg = 6V; needs 2 barriers | |
MTL7761ac | 1/2 | Vwkg = 6V; needs 2 barriers | |
|
Analogue Input - strain-gauge bridges (single) |
|||
Power Supply | Barrier |
Loops
|
Volts for 350 ohm bridge |
IIC gases |
MTL7761ac (2) + MTL7764ac (1) |
1 | 9.75V from MTL7766Pac with 20V supply |
|
Analogue Input - strain-gauge bridges (multiple) |
|||
Power Supply | Barrier |
Loops
|
Volts for 350 ohm bridge (20V in) Number of bridges 1.............2..........3............4 |
IIC gases |
MTL7761ac (2) + MTL7766ac (1) |
1 | 13.0........9.2.......7.7.........6,2 |
|
Analogue Output - controller outputs (I/P converters) |
||||
Power Supply | Barrier |
Loops
|
Volt drop at 20mA |
Main features |
Output goes to 0V (earth return); regulated supplies | MTL7728+ |
1 |
6.8V | – |
MTL7728P+ | 1 | 5.1V | Higher power, IIC gases | |
MTL7729P+ | 1 | 3.7V | Higher power, IIB gases | |
Transistor between controller output and 0V; (diode return); regulated supplies | MTL7787+ | 1 | 8.1V | – |
MTL7787P+ | 1 | 6.4V | Higher power, IIC gases | |
Transistor between controller output and 0V; (diode return); unregulated supplies (20 to 35V) | MTL7707+ |
1
|
8.6V | – |
MTL7707P | 1 | 6.0V | Higher power, IIC gases | |
|
Digital Input - switches |
|||
Power Supply | Barrier |
Loops
|
Main features |
Regulated | MTL7787+ | 1 | Diode return |
MTL7787P+ | 1 | ||
MTL7789+ | 2 | ||
|
Digital Input - switches / proximity detectors |
|||
Power Supply | Barrier |
Loops
|
Main features |
Unregulated 22-35V | MTL7741 | 1 | Changeover relay output |
MTL7742 | 1 | Transistor output, fast switching | |
MTL7743 | 2 | 2 x relay contacts | |
MTL7744 | 2 | 2 x transistor output | |
MTL7745 | 1 | Single channel relay + LFD | |
|
Digital Output - alarms, LEDs, solenoid valves, etc |
||||
Power Supply | Barrier |
Loops
|
Usable power per loop | Main features |
Switch in power leg, (earth return); regulated supplies | MTL7728+ |
1 |
0.48W | – |
MTL7728P+ | 1 | 0.59W |
Higher power, IIC gases Voltage drop = 5.1V at 20mA |
|
MTL7729P+ | 1 | 0.82W | Higher power, IIB gases | |
Control switch on earth (diode return); regulated supplies | MTL7787+ | 1 | 0.42W | – |
MTL7787P+ | 1 | 0.51W | Higher power, IIC gases | |
Transistor between controller output and 0V; (diode return); unregulated supplies (20 to 35V) | MTL7707+ |
1
|
0.29W | Up to 35mA available |
MTL7707P+ | 1 | 0.68W | Optimised for IIB gases | |
|
Digital Input/Output - –ve and floating supplies |
|||
Power Supply | Barrier |
Loops
|
Volts for 350 ohm bridge |
Regulated negative/floating power supply |
MTL7728– | 1 | – |
|
2-wire DC/AC systems - signal returns |
||||
System or Function | Barrier |
Loops
|
Vwkg | Main features |
6V dc systems | MTL7710+ |
1 |
6.0V | – |
8V dc system | MTL7710P+ | 1 | 8.0V |
End ot end resistance 42 ohm. 5V at 65mA from 8V supply. IIC gases |
Low-level logic returns | MTL7764+ | 2 | 10.0V | End-to-end resistance 1050 ohms |
12V dc systems | MTL7715+ | 1 | 12.0V | – |
MTL7715P+ | 1 | 12.6V | – | |
18V dc systems | MTL7722+ | 1 | 19.6V | – |
2-wire dc/ac systems | MTL7778ac | 1 | 24.0V | – |
Signal returns | MTL7789+ |
2
|
26.6V | 2 diode return channels + power |
Securing cables to earth for future use; terminating cable screens | MTL7799 | – | – | Bussed power feed - not certified |
MTL4500 Series Barriers MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
MTL4501-SR, MTL4504, MTL4510, MTL4510B, MTL4511, MTL4513, MTL4514 (B)(D), MTL4516, MTL4516C, MTL4517, MTL4521, MTL4521L, MTL4523, MTL4523L, MTL4523R, MTL4523V, MTL4523VL, MTL4524, MTL4524S, MTL4525, MTL4526, MTL4531, MTL4532, MTL4533, MTL4541, MTL4541A, MTL4541AS, MTL4541B, MTL4541P, MTL4541S, MTL4541T, MTL4544, MTL4544A, MTL4544AS, MTL4544B, MTL4544D, MTL4544S, MTL4546, MTL4546C, MTL4546S, MTL4546Y, MTL4549, MTL4549C, MTL4549Y, MTL4561, MTL4575, MTL4576-RTD, MTL4576-THC, MTL4581
MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
MTL7707+ Shunt-Diode Safety Barrier MTL7707+ Protected Barriers
We are specialized in intelligent instruments, including : control system, transmitters, flow meters,sensors, recorders, analyzers, control valves, controllers, PLC's, etc.
We mainly supply Yokogawa, Emerson, Rosemount, Fisher, Honeywell, Siemens, ABB, FLUKE, Endress+Hauser, Schneider Electric, Pepperl+Fuchs, MTL, Rockwell(Allen Bradley), Hirschmann, Eaton, Moeller, FUJI, Omron, Yaskawa, Norgren, CHINT, Hach, Weidmuller, Phoenix, SMC, Testo, ASCO, Parker, Mitsubishi, Festo, GE, CISCO, Auma, IFM, GM, Turck, Bently Nevada, MOXA, Krohne, Foxboro and so on.
Why do you choose us?
1. 100% original brand product, 100% quality assurance.
If you find a fake product. Please contact us without hesitation! We afford the shipment cost! We send you a new product asking zero cent.
2. Varied payment methods.
We adopt L/C, D/A, D/P, T/T, and other methods. If you can not trust us , you can choose to pay it via Aliexpress! 100% make your money safe!
Packaging: Imported with original packaging or standard export packing.Customize design is acceptable.
Shipping: By Express(EMS,DHL,UPS,TNT, FEDEX, ARAMEX), By Air, By Sea.
Contact:
HONGKONG XIEYUAN TECH CO., LIMITED
Email:becky@hkxytech.com Web:www.hkxytech.com
Mobile:+86-15972186287(Whatsapp & Wechat)